E46Fanatics - Search Results E46 BMW Social Directory E46 FAQ 3-Series Discussion Forums BMW Photo Gallery BMW 3-Series Technical Information E46 Fanatics - The Ultimate BMW Resource BMW Vendors General E46 Forum The Tire Rack's Tire Wheel Forum Forced Induction Forum The Off-Topic The E46 BMW Showroom For Sale, For Trade or Wanting to Buy

Go Back   E46Fanatics > Search Forums

You searched for the keyword(s):
Your search results are listed below. If you did not find the answer you were looking for, please try searching again. Make sure that you are searching the entire site and not a specific forum. If you cannot find the answer to your question, create a new discussion topic in the appropriate BMW related or Off-Topic section.

Showing results 1 to 6 of 6
Search took 0.01 seconds.
Search: Posts Made By: m54e30t
Forum: Driveline, Engine & DME Tuning 09-03-2018, 10:47 PM
Replies: 31
Views: 2,765
Posted By m54e30t
When i say it's maxing out at 902kg/hr, thats...

When i say it's maxing out at 902kg/hr, thats because what your MAF scalar has in the last cell.

In the bin i sent you, i scaled the MAF correctly and it would actually be 18xx kg/hr.

Remember,...
Forum: Driveline, Engine & DME Tuning 09-03-2018, 08:08 PM
Replies: 31
Views: 2,765
Posted By m54e30t
His comment stated that after changing the...

His comment stated that after changing the conversion factor, he believed his MAF voltage was changing.
Conversion factors, or even the decimal changes in the table cannot alter the MAF voltage.
...
Forum: Driveline, Engine & DME Tuning 08-29-2018, 03:26 PM
Replies: 31
Views: 2,765
Posted By m54e30t
The conversion factor changes nothing in the...

The conversion factor changes nothing in the tune, so no, it had no impact on your maf.
Forum: Driveline, Engine & DME Tuning 08-28-2018, 11:28 PM
Replies: 31
Views: 2,765
Posted By m54e30t
Whats the conversion factor on the MAF table in...

Whats the conversion factor on the MAF table in your XDF? when you apply the MAF hack in the full flash, you need to modify the conversion factor on the MAF table to be 2x the original i.e....
Forum: Driveline, Engine & DME Tuning 08-27-2018, 08:23 PM
Replies: 31
Views: 2,765
Posted By m54e30t
This picture demonstrates that you *could* be...

This picture demonstrates that you *could* be maxing the load limits in the DME around the point you are speaking depending on what your MAF kg/hr readings are....
Forum: Driveline, Engine & DME Tuning 08-27-2018, 08:13 PM
Replies: 31
Views: 2,765
Posted By m54e30t
From memory the rev limit is set around 5200-5300...

From memory the rev limit is set around 5200-5300 when theres no speed signal.
Have you tried logging vehicle speed to see if its actually registering anything?

Other than that, its possible...
Showing results 1 to 6 of 6

 

All times are GMT -5. The time now is 06:02 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
(c) 1999 - VerticalScope Inc. All rights reserved.