E46Fanatics - Search Results E46 BMW Social Directory E46 FAQ 3-Series Discussion Forums BMW Photo Gallery BMW 3-Series Technical Information E46 Fanatics - The Ultimate BMW Resource BMW Vendors General E46 Forum The Tire Rack's Tire Wheel Forum Forced Induction Forum The Off-Topic The E46 BMW Showroom For Sale, For Trade or Wanting to Buy

Go Back   E46Fanatics > Search Forums

You searched for the keyword(s):
Your search results are listed below. If you did not find the answer you were looking for, please try searching again. Make sure that you are searching the entire site and not a specific forum. If you cannot find the answer to your question, create a new discussion topic in the appropriate BMW related or Off-Topic section.

Showing results 1 to 25 of 61
Search took 0.01 seconds.
Search: Posts Made By: 2bimmers420
Forum: General E46 Forum 09-24-2019, 09:53 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
@thecos heat the cap to make it flexible. It...

@thecos heat the cap to make it flexible. It wonít be by much but itís worth a shot. Carefully pry each tab until the cap is off good luck


Sent from my iPhone using E46Fanatics
Forum: General E46 Forum 09-22-2019, 12:21 PM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Your pics donít show btw Sent from my...

Your pics donít show btw


Sent from my iPhone using E46Fanatics mobile app (http://r.tapatalk.com/byo?rid=92578)
Forum: General E46 Forum 09-22-2019, 12:21 PM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Use a heat gun and be very patient. Chances are...

Use a heat gun and be very patient. Chances are itís gunna break though. We got guys on this thread fabricating there own but itís all still experimental. I was lucky to score one my self. My advice,...
Forum: General E46 Forum 08-29-2019, 02:26 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
[ATTACH]782735 @beechbmwThis is the pin hole...

[ATTACH]782735
@beechbmwThis is the pin hole before I drilled in to it tommarow Iíll post after since I forgot and itís to dark
@omgwtfi got the same set up as beechbmw except I got a catch can...
Forum: General E46 Forum 08-28-2019, 07:47 PM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
I eliminated the positive crankcase. Pressure! In...

I eliminated the positive crankcase. Pressure! In comparison to the original cap. The vent hole is slightly smaller in the ALU cap particularly towards the inside. I used a 1/16 drill bit to...
Forum: General E46 Forum 08-28-2019, 04:55 PM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Iíve had the m56 valve cover with a plastic cap...

Iíve had the m56 valve cover with a plastic cap with membrane held in place with gasket maker. Also cc. Delete with catch can. I always noticed vacuum when I open oil cap. The positive pressure was a...
Forum: General E46 Forum 08-28-2019, 09:24 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
I think you might be on to something. Everything...

I think you might be on to something. Everything else is exactly identical except that hole. I also notice it was smaller I had a hard time finding anything to poke through. Not even my smallest...
Forum: General E46 Forum 08-28-2019, 07:12 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
@ beechbmw. Thanks for the acknowledgment;) so...

@ beechbmw. Thanks for the acknowledgment;) so these videos are proving that the alu cap is correctly made right? And if so what is to explain the pressure weíre experiencing?? Iím just very...
Forum: General E46 Forum 08-26-2019, 02:18 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
I suspect my leak is coming from the oil fill cap...

I suspect my leak is coming from the oil fill cap even though the m56 VC spits oil when idling with lid open. I donít think the seal is supposed soaked in oil all around. I swapped I both can...
Forum: General E46 Forum 08-25-2019, 02:18 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
[My home madesmoker. Slapped it together in 15...

[My home madesmoker. Slapped it together in 15 min ;)


Sent from my iPhone using E46Fanatics mobile app (http://r.tapatalk.com/byo?rid=92578)
Forum: General E46 Forum 08-25-2019, 02:18 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Damn P0171 came back any ideas anyone? I did a...

Damn P0171 came back any ideas anyone? I did a smoke test pumped a bunch of smoke through the port at the back of the engine. Saw no visual leaks. But it defiantly runs like there is a vacuum leak....
Forum: General E46 Forum 08-25-2019, 12:08 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Cap and diagnostic PIDs. What is concidered...

Cap and diagnostic PIDs. What is concidered normal


Sent from my iPhone using E46Fanatics mobile app (http://r.tapatalk.com/byo?rid=92578)
Forum: General E46 Forum 08-25-2019, 12:05 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Ok installed the cap. So these are my...

Ok installed the cap. So these are my measurements, Iíve also been working with a crankshaft position sensor issue. So itís hard to compare before and after.
So first off I cut the tip off a sewing...
Forum: General E46 Forum 08-24-2019, 01:23 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
@omgwtf. How are you getting these measurement?...

@omgwtf. How are you getting these measurement? Are you installing the cap stick the pin and mark it? And how do you measure the movement? Do I run the car @ idle and measure?


Sent from my...
Forum: General E46 Forum 08-24-2019, 01:16 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
@omgwtf. How are you getting these measurement?...

@omgwtf. How are you getting these measurement? Are you installing the cap stick the pin and mark it? And how do you measure the movement? Do I run the car @ idle and measure?


Sent from my...
Forum: General E46 Forum 08-23-2019, 10:16 PM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
@parklas Touchdown in SoCal! Got my new cap I...

@parklas Touchdown in SoCal! Got my new cap I happened to have a new Russian membrane, i also still have my old cap and will take measurements. What exactly am I measuring?? And if I find a local...
Forum: General E46 Forum 08-21-2019, 03:14 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Hahahaha his egos to big for the nickle ...

Hahahaha his egos to big for the nickle


Sent from my iPhone using E46Fanatics mobile app (http://r.tapatalk.com/byo?rid=92578)
Forum: General E46 Forum 08-21-2019, 03:12 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Put me down for another cap plus 2 disks!? Good...

Put me down for another cap plus 2 disks!? Good to have you back. Cap should be hitting my mail any day now!!


Sent from my iPhone using E46Fanatics mobile app...
Forum: General E46 Forum 08-21-2019, 03:03 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Same here I have the membrane sitting here...

Same here I have the membrane sitting here awaiting the same cap -__-


Sent from my iPhone using E46Fanatics mobile app (http://r.tapatalk.com/byo?rid=92578)
Forum: General E46 Forum 08-15-2019, 06:36 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
WTH is going on?!? Was parklas able to recieve...

WTH is going on?!? Was parklas able to recieve our info he requested even though things all screwed up?!?


Sent from my iPhone using E46Fanatics
Forum: DIY: Do It Yourself 08-13-2019, 07:46 AM
Replies: 68
Views: 126,772
Posted By 2bimmers420
Itís been a while, but I hope some one with good...

Itís been a while, but I hope some one with good advice will see this. First off I have E39 530i . Up until recently it had been sitting in the drive way under a cover for several months. Mainly do...
Forum: General BMW Model Discussion 08-13-2019, 05:42 AM
Replies: 1
Views: 356
Posted By 2bimmers420
E39 rack and pinion DIY rebuild

So I have an 02 530i,I do all the repairs and maintenance myself Iíve done from Oil changes and DISA replacements to SULEV valve cover upgrade and vanos O-rings and anti-raddle Kit. Iíve replaced...
Forum: General E46 Forum 08-13-2019, 05:12 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Wow impressive. I personally like the idea of an...

Wow impressive. I personally like the idea of an aluminum cap. Although Iíll benifit greatly from parklas cap. Iíd definitely be interested in sampling one of yours for my 328 I got with a blow head...
Forum: General E46 Forum 08-13-2019, 04:59 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
This is what I recommend to you guys when...

This is what I recommend to you guys when silverdogz requested ideas the first time. Glad you finally got it though. Now time to catch up on this topic. Looks like I missed a lot!


Sent from my...
Forum: General E46 Forum 08-11-2019, 10:23 AM
Replies: 1,404
Views: 168,064
Posted By 2bimmers420
Alright the time has finally come patience is a...

Alright the time has finally come patience is a virtue, only curious. Have we shipped out any orders yet?


Sent from my iPhone using E46Fanatics mobile app (http://r.tapatalk.com/byo?rid=92578)
Showing results 1 to 25 of 61

 

All times are GMT -5. The time now is 04:32 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
(c) 1999 - VerticalScope Inc. All rights reserved.